What You Will need:

  • Diamond Core Drill (often referred to as Diamond Hole Saws)
  • Towel or wood, something to rest your mirror on whilst drilling
  • Putty or water containment suction ring
  • Flow of water (either a running tap or a hose)
  • Safety goggles
  • Face mask
  • Diamond fileto bevel away the finished edges (optional)

Disclaimer. Using rotary tools near water has never been, to the best of our knowledge, endorsed by any of the rotary tool manufacturers. If you do choose to drill near water or with attachments under water connected to your drill then you do so at your own risk. Please be aware that mixing electricity and water can be very dangerous.

Step 1

Mark the position of where you require the hole to be with a marker and place a strip of masking tape over the top. When you begin to drill the masking tape will help prevent any skittering across the surface of the mirror.

Step 2

Start your tap running or your hose so that there is a constant flow of water running over the drill hole. The purpose of using a lubricant such as water is to ensure the material and your drill bit do not overheat which can cause your material to crack and will shorten the life of your drill bit.

Step 3

Start the drill on it’s lowest rpm setting to begin with and angle your drill on the masking tape. The angling of the drill will again help to prevent any skittering across the surface. Once you have made the initial cut by angling the piece into the mirror create a moulded ring with some putty or if you have one attach a water containment suction ring. These will help the water form a pool around the drilling area and also help to guide you as well.Return your drill to it’s normal vertical position and continue to drill through.

Step 4

If you need the hole to look neat and professional try using one of our diamond files to bevel away the sharp edges and give your mirror a nice smooth finish. For further help, you might also like to read our article:12 Things you Should Know about Diamond Drill Bits